HP NetServer LC 2000r Installation Manual page 68

Chapter 5
6. Repeat Steps 2 through 5 to remove any additional desired DIMMs on the
system board.
NOTE Ensure the retaining clips on the DIMM slots for each DIMM
are closed before replacing the cover onto the HP NetServer.
An error will be displayed if all DIMMs are removed.
7. If all desired DIMMs have been removed, replace the cover.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
8. If the NetServer is a rack installation, return the chassis into the rack.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
9. Re-install the bezel onto the front of the HP NetServer.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
10. Reconnect the power cord(s).
11. Power on the HP NetServer according to the respective NOS power-up
instructions.
Refer to Chapter 2, "Controls, Ports, and Indicators."
12. Return the HP NetServer to normal operation.
60
Figure 5-4. Removing a DIMM Module
Installing Additional Memory