Memory Installation Guidelines; Dimm Installation - HP NetServer LC 2000r Installation Manual

Chapter 5

Memory Installation Guidelines

The HP NetServer LC 2000/2000r uses only 133 MHz (PC133) SDRAM
DIMMs, which are electrically different from the EDO and PC100
SDRAM memory modules used in previous HP NetServer models.
DIMM sizes supported are 64 MB, 128 MB, 256 MB, 512 MB, or 1 GB in
any combination.
Supported memory capacity ranges from 64 MB to 4 GB maximum (1 GB
per DIMM slot and 4 DIMM slots total). The minimum capacity is 64 MB
(one DIMM).
DIMM sizes may be mixed on the system board and may be loaded in any
order (0 through 3).
Open slots between DIMMs are permitted.
When handling DIMMs, observe anti-static precautions to avoid damage.

DIMM Installation

Use this procedure to install each DIMM in a DIMM slot on the system board.
CAUTION
Do not install EDO DIMMs or PC100 SDRAM from previous
HP NetServers in the HP NetServer LC 2000/2000r. Use only
DIMMs specified for the HP NetServer LC 2000/2000r.
56
Figure 5-1. Individual SDRAM DIMM
Installing Additional Memory