Table of Contents
Advertisement
Install the DIMM.
7.
Install the access panel (on page 25).
8.
Install the server into the rack
9.
Connect each power cord to the server.
10.
Connect each power cord to the power source.
11.
Power up the server (on page 23).
12.
Use RBSU
("HP ROM-Based Setup
For more information about LEDs and troubleshooting failed DIMMs, see "Systems Insight Display LED
combinations (on page 12)."
Hot-plug hard drive options
When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest device number.
•
Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Installing a hot-plug SAS or SATA hard drive
The server can support 8 SAS or SATA hard drives in a SFF or LFF configuration, or the following
configurations with the optional hard drive cage
•
12 LFF
•
16 SFF
•
25 SFF
To install the component:
("Installing the server into the
Utility" on page 103) to configure the memory mode.
("Hard drive cage
rack" on page 40).
option" on page 76):
Hardware options installation 59
Advertisement
Table of Contents
