Table of Contents
Advertisement
Running the demonstration
Figure 47. Setting the wakeup time
Once the alarm has been configured, the red LEDs stop blinking and the system enters
Standby mode. The message shown in
Figure 48. RTC Alarm wakeup configured
After the programmed timing has elapsed, the system exits Standby mode and a system
reset signal is generated.
Note:
If the time and date have not been set, the message shown in
LCD screen.
Figure 49. Time and Date configuration prompt
36/49
HH:MM:SS
Figure 48
MCU in Standby Mode
Wait For RTC Alarm
Time and Date are
not configured,
please go to the
Calendar menu and
set time and Date
parameters. Press
joystick to continue...
Doc ID 18064 Rev 1
is then displayed on the LCD.
Figure 49
UM1011
is displayed on the
Advertisement
Table of Contents
Need help?
Do you have a question about the STM32100E-EVAL and is the answer not in the manual?
Questions and answers