Call Recording; To Configure A Record Key Via Phone User Interface - Yealink SIP-T42G User Manual

In the following figure, the LCD screen shows an incoming call from 1001 on the
monitored line.
Note
If your phone is locked and the type of the keypad lock is configured as Function Keys or
All keys, you cannot use the Dpickup, Dial, New Call and Cancel soft keys until unlocked.
When there is an active call on the IP phone, you can transfer the active call to the
monitored phone number directly by pressing the BLF key. The phone transfers the
active call differently depending on the transfer mode on DSS key. For more information
on the transfer mode on DSS key, refer to transfer in
You can record calls by pressing a record key on the phone. The SIP-T42G IP phone
supports record and URL record.
Two ways of call recording:
Record: The phone sends a SIP INFO message containing a specific header "Record:

on/off" to trigger a recording.
URL Record: The phone sends an HTTP URL request to trigger a recording. Contact

your system administrator for the predefined URL.
Call record is not available on all servers. Contact your system administrator for more
Note
information.

To configure a record key via phone user interface:

1. Press Menu->Features->DSS Keys.
2. Select the desired DSS key.
3. Press
4. Press
5. (Optional.) Enter a string that will appear on the LCD screen in the Label field.
6. Press the Save soft key to accept the change or the Back soft key to cancel.
or , or the Switch soft key to select Key Event from the Type field.
or , or the Switch soft key to select Record from the Key Type field.
Advanced Phone Features
DSS Keys section on page 47.
99