Installing 3.5" Hot-Swap Hard Drive - Chenbro ES340 User Manual

ES340 Chassis
User's Manual
3
■ Slide in the assembled CD-ROM into the chassis
Installing 3.5" SATA2 Hard Drive:
1
■ Remove the HDD Carrier from the chassis and place
the SATA2 HDD into it.
3
■ Slide in the assembled HDD into the chassis, suggest
install by the ID definition on the front panel (No need to
remove the front bezel)
www.chenbro.com
4
■ Make sure the holder latch is secured when fully
seated
2
■ Attach the HDD screws on both sides
4
■ Make sure the carrier is fully seated
11