Air Circulation; Moving The Projector; Installing The Projector Properly - Eiki LC-XNS2600 Owner's Manual

Safety Guide

Air circulation

Vents in the cabinet are provided for ventilation.
To ensure reliable operation of the product and to
protect it from overheating, these openings must
not be blocked or covered.
Caution
Hot air is exhausted from the exhaust vent.
When using or installing the projector, the
following precautions should be taken.
- Do not put any flammable objects, or spray
can near the projector. Hot air is exhausted
from the air vents.
- Keep the exhaust vent at least 1m away from
any objects.
- Do not touch a peripheral part of the exhaust
vent, especially screws and metallic part. This
area will become hot while the projector is
being used.
- Do not put anything on the projector. Objects
put on the cabinet will not only get damaged
but also may cause fire hazard by heat.
- Cooling fans are provided to cool down the
projector.
The fan's running speed is changed according
to the temperature inside the projector.
Air Intake Vent
Air Intake Vent

Moving the projector

When moving the projector, take care of the
lens and retract the adjustable foot to prevent
damage to the lens and cabinet.
6

Installing the projector properly

Please set the projector on nearly-level.
Be sure to install the projector properly. Improper
installation may reduce the lamp lifetime and even
cause a fire hazard.
- Only qualified personal is authorized for ceiling
installation.
- We are not responsible for the hurt and damage
caused by ceiling brakect that purchased from
unauthorized dealer even in warranty period.
- Remove the ceiling bracket immediately while not
use.
- While installing, torque screwdriver is suggested,
don't use electric or impact-type screwdriver.
- Please read the manual of bracket for details.
- The bracket is subject to change without notice.
Exhaust Vent
– Do not drop or bump the projector, otherwise
damages or malfunctions may result.
– When carrying the projector, use a suitable
carrying case.
– Do not transport the projector by courier or
any other transport service in an unsuitable
transport case. This may cause damage to the
projector. For information about transporting
the projector by courier or any other transport
service, consult your dealer.
– Do not put the projector in a case before it is
cooled enough.
Do not roll the projector over 20
degrees from side to side.
Metal noise can be heard from inside
when the projectior is inclined. That is not
a defect. This is noise of a component
inside.
Do not point the projector up to
project an image.
Do not point the projector down to
project an image.
Do not put the projector on either
side to project an image.
Caution in ceiling installation the projector
Caution in moving or transporting the
projector
M4x10
10mm
Torque:1.40N.m