Eiki LC-XNS2600 Owner's Manual page 60

Appendix
No Sound
The color is abnormal
Auto PC adj. function does not
work.
The Settings cannot be saved
after turing off the projector.
Power management function does
not work.
Logo function does not work.
Auto setup function does not work. - Make sure no function in the Auto setup menu is set to "Off".(Page 43)
The image is distorted or
disappears.
PIN code dialog box appears at
start-up
The remote control does not work. - Check the batteries.
Indicators light or flash.
Exclamation mark appears on the
screen.
Top control cannot be operated.
Unable to unlock the Logo PIN
code, Key lock or PIN code lock.
Warning:
High voltages are used to operate this projector, do not attempt to open the cabinet.
If the problem still exists after you take the aforesaid measures, you should contact the local distributor
or the repair center and tell the machine model. We will tell you how to handle the issue.
60
- Check the audio cable connection from audio input source.
- Adjust the audio source.(Page 25)
- Press the VOLUME + button.(Page 25)
- Press the Mute button.
- When the AUDIO OUT is plugged in, the projector's built-in speaker is not
available.
- Is the image projected? The sound can only be heard when the image is
projected.
- Check the input signal, color system, video system or computer system
mode.
- Make sure that Blackboard is not selected in Image Mode menu.
- Check the Input signal. Auto PC adj. function can not work when
480p, 576p, 720p, 480i, 576i, 1035i or 1080i is selected.(Pages 34-35)
- Make sure you selected "Store" after adjusting settings.
- Power management function can not work while Freeze or Blank function
is running.(Page 46)
- Check connections and input source.
- Make sure "On" is not chosen in the Ceiling function.(Page 32)
- Check and adjust "PC adjust" menu or " Screen size" menu.
- PIN code lock is being set.
- Make sure no obstruction is between the projector and the remote control.
- Make sure you are not too far from the projector when using the remote
control. Maximum operating range is 5m.
- Unlock the Key lock function in the Setup menu for the remote control.
(Page 41)
- Refer to Indicators and projector condition to check the status of the
projector.(Page 61)
- Your operation is invalid. Operate correctly.
- Unlock the Key lock function in the Setup menu for the top control.
(Page 41)
- Contact the dealer or the service center.