Planet SGSW-24040 User Manual page 337

tep 6: After the Stack Master and Members have been configured, any switch in the stack can be managed from the web
S
agent by choosing the desired Member ID from the Switch drop down menu. To connect to a Member switch through
CLI, use the rcommand.
Slave switch IP will be covered by Master one, and disappear temporarily. The slave IP
address can be the same as Master IP address. Thus, if master switch is malfunction, you
can still access the other switch by same IP address.
If you have difficulty on selecting another switch, you may be connecting to the slave
switch's web, please close the browser window, use the "arp –d * " DOS command to
the ARP table and then reopen the web.
Figure 4-17-16 To manage the member swit ch
316
User's Manual of SGSW-24040 / 24240 Series
the
clear