Correct Usage - Toshiba Super MMU-AP0092H Service Manual

4-4. Correct Usage

• When you use the air conditioner for the first time or when you change the SET DATA value, follow the
procedure below. From the next time, the operation displayed on the remote controller will start by pushing
ON / OFF
the button only.
n Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
∗ After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute,
but it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with
and the leak breaker.
• When you use the air conditioner after it has not been used for a long period, turn on the power switch at
least 12 hours before starting operation.
TEMP.
4
TIMER SET
TIME
FILTER
RESET TEST SET CL
Start
1
ON / OFF
Push button.
The operation lamp goes on, and the operation
starts.
2
Select an operation mode with the
MODE
"MODE " button.
One push of the button, and the display
changes in the order shown as follows.
• " DRY mode" function is not provided to
Concealed Duct High Static Pressure Type.
Cooling only model
DRY
Heat-pump model
HEAT DRY
(Dehumidify)
ON / OFF
3
FAN MODE
SAVE VENT
SWING/FIX UNIT LOUVER
COOL FAN
COOL FAN
ON / OFF
button without turning off the main power switch
3
Select air volume with "
One push of the button, and the display changes
in the order shown as follows.
1
AUTO
2
• When air volume is "
differs according to the room temperature.
• In DRY mode, "
the air volume is LOW.
• In heating operation, if the room temperature is
not heated sufficiently with VOLUME "
operation, select "
operation.
• The temperature sensor senses temperature
near the air inlet of the indoor unit, which
differs from the room temperature depending
on the installation condition.
A value of setting temperature is the measure
of room temperature. ("
selectable in the FAN mode.)
• Air volume of function is not provided to
"Concealed Duct High Static Pressure Type"
but air speed "
4
Determine the set up temperature by push-
ing the "TEMP.
Stop
ON / OFF
Push
The operation lamp goes off, and the operation stops.
21
FAN
" button.
HIGH MED.
AUTO", air volume
AUTO" is displayed and
MED." or "
AUTO" is not
HIGH" only is displayed.
" or "TEMP.
button.
LOW
LOW"
HIGH"
" button.