Toshiba Super MMU-AP0092H Service Manual page 78

n Function selection setup
<Procedure> Perform setting while the air conditioner stops.
1
TEST SET CL
Push + +
The first displayed unit No. is the master indoor unit address in the group control.
In this time, fan and louver of the selected indoor unit operate.
2
UNIT LOUVER
Every pushing
displayed one after the other.
In this time, fan and louver of the selected indoor unit only operate.
3
Using the set temperature
4
Using the timer time
5
SET
Push button. (OK if indication lights)
• To change the selected indoor unit, proceed to Procedure
• To change item to be set up, proceed to Procedure
6
TEST
Pushing button returns the status to the normal stop status.
buttons simultaneously for 4 seconds or more.
ò
button (button at left side), the indoor unit No. in the group control is
ò
buttons, specify the item code (DN).
TEMP.
ò
TIME buttons, select the set data.
ò
ò
TEMP.
3
6
FILTER
RESET TEST
1
<Operation procedure>
1 2 3
2
.
3
.
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
4 5 6
END
78
4
5
2