Toshiba Super MMU-AP0092H Service Manual page 109

No. Part name
1. Detachment
4 Ceiling panel
1) Carry out works of item 1 of 2 and item 1
2) Remove the flap connector
NOTE :
Unlock the lock of the housing part and then
remove the connector.
3) Loosen the panel fixing 4 screws.
4) Slide the panel fixing brackets
5) Push the tentative bracket outward and
2. Attachment
1) Insert the tentative brackets (2 positions)
NOTE :
The ceiling panel has the directional
properties against the indoor unit.
Direct the louver motor wire to the electric
parts box side of the indoor unit.
2) Pass the head of the panel fixing screw
3) Tighten in the panel fixing screw to fix the
4) Following to work of item 2 of 3 , attach
5) Connect the louver connector
6) Following to work of item 2 of 2 , mount
Procedure
of 3 .
(CN510, White, 20P) connected to the
control P .C. board and then remove the
lead wire from the clamp.
(4 positions) outward.
then remove the ceiling panel.
of the ceiling panel into square holes of
the indoor unit and then hook the panel
tentatively.
through hole of the panel fixing bracket
and then slide the panel fixing bracket
inward.
ceiling panel.
the adjust corner cap as before.
(CN510, White, 20P) as before and then
fix the lead wire with clamp.
the electric parts box cover and the
suction grille as before.
Clamp
Panel fixing screw
Tentative bracket
Push in case Push in case Push in case
of removing of removing of remo
Square hole of indoor unit
Inner side Inner side Inner side
Sliding direction Sliding direction Sliding direction
109
Remarks
Louv Louver motor wir Louver motor wiring er motor wiring
CN510
Square hole of indoor unit
Electric parts box
Louver motor wiring Louver motor wir Louv er motor wiring
Ceiling panel
Square hole of indoor unit
ving
Tentative bracket
Panel fixing screw Panel fixing scre anel fixing screw
Panel fixing br Panel fixing bracket anel fixing brac
Outer side Outer side Outer side
ing
acket et