Toshiba Super MMU-AP0092H Service Manual page 80

n How to change all indoor addresses from an arbitrary wired remote controller
(It is possible when setting has finished by automatic addresses.)
Contents: The indoor unit addresses in each identical refrigerant piping line can be changed from an
arbitrary wired remote controller.
¤ Enter in address check/change mode and then change the address.
<Procedure> Carry out this procedure during stop of system.
1
Push the timer time button
First line 1 and item code
2
Select line address using
3
SET
Push the button.
• The address of the indoor unit connected to the
refrigerant piping of the selected outdoor unit is
displayed and the fan and the louver are on.
First the current indoor address is displayed.
(Line address is not displayed.)
4
TIME
button push up/down the indoor
address of the SET DATA.
The set data is changed to a new address.
5
SET
Push button to determine the set data.
6
UNIT LOUVER
Every pushing
No. in the identical piping is displayed one
after the other.
• Only fan and louver of the selected indoor unit
start operation.
Repeat the Procedures
indoor addresses so that they are not duplicated.
7
SET
Push button.
(All the indications of LCD go on.)
8
TEST
Push button and then the procedure
finishes.
TEST
+ simultaneously for 4 seconds or more.
)+
(Address Change) are displayed.
ò
UNIT LOUVER
SWING/FIX
/ button.
ò
ò
ò
ò
button, the indoor unit
4 6
to to change all the
ò
ò
TEMP.
1
FILTER
RESET TEST
3
Cancel of line selection
If the UNIT No. is not call up here, the outdoor unit
in that line does not exist.
CL
Push button to select a line again in the
2
Procedure .
1
TEMP.
8
FILTER
Finish
RESET TEST
5
<Operation procedure>
1 2 3
6 7 8
80
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
When you want to
complete the setting
4 5
END
2
4
6
7