Toshiba Super MMU-AP0092H Service Manual page 67

u In case of wireless remote controller
Procedure
Push [ON/OFF] button on the remote controller.
1
Change the operation mode to [COOL] or [HEAT] using [MODE] button and then select the air speed [
using [FAN].
Test run for cooling operation
2
Set [18°C] using [Temperature set] button.
3 Set [19°C] using [Temperature set] button immediately
after confirmation of the receiving sound "Pi".
Set [18°C] using [Temperature set] button immediately
4
after confirmation of the receiving sound "Pi".
Next carry out the procedures
After approx. 10 seconds, all the indication lamps on the receiving part of the wireless remote controller [ON],
5
[TIMER] and [Ready] flash and start the operation.
Repeat operation of procedure
6
After the test run, push [ON/OFF] button to stop the operation.
<Outline of test run from wireless remote controller>
Test run for cooling operation:
ON/OFF → 18°C → 19°C → 18°C → 19°C → 18°C → 19°C → 18°C → (Test run) → ON/OFF
Test run for heating operation:
ON/OFF → 30°C → 29°C → 30°C → 29°C → 30°C → 29°C → 30°C → (Test run) → ON/OFF
Note) The test run returns to the normal operation after 60 minutes.
Always select
[ HIGH] air volume.
Operation contents
3 → 4 → 3 → 4
.
2
and after if the lamps do not flash.
2
2
67
Test run for heating operation
Set [30°C] using [Temperature set] button.
Set [29°C] using [Temperature set] button immediately
after confirmation of the receiving sound "Pi".
Set [30°C] using [Temperature set] button immediately
after confirmation of the receiving sound "Pi".
3, 4, 5, 6
2, 7
H]