3.1
GETTING STARTED
The Getting Started section will take you through the frequently used operations and assist
you to customize the look of the GPS Chart Plotter.
3.1.0
Power On, Off and ShuttlePoint Knob operation
1. Press and hold [PWR] until the display shows the Start-Up page (see the following
picture). To turn Off, press and hold [PWR] until the display turns Off.
2. When the power is first turned on two pages the start-up page and the Caution pages are
briefly shown before the GPS Status page.
The Caution page on the left is shown only if the data C-CARD is over one year old.
3. When the GPS Chart Plotter is first turned on it will take some time for the GPS to acquire
a fix of your position. Look closely at the GPS Status page and you will see satellites and
relative signal strengths of each satellite. After a fix is received the GPS Chart Plotter
will automatically switch to the Chart Page with the ship icon centered on the screen.
CPF180i and CPF300i
Figure 3.1.0 - Example of Start-Up page on CPF180
Figure 3.1.0a - Example of Caution pages
NOTE
WARNING
Page 33