Table of Contents
Advertisement
*NOTE
RS232 not opto-isolated electrical interface.
2.4.3
CPF300i Connections
2.4.3.0 DC Power Connection
CPF300i
Transducer
2.4.3.1 Connection a VideoCamera, AIS Receiver, VHF and Autopilot
VIDEO
Camera
CPF300i
Transducer
The Input and Output baud rate for each port is set using the Advanced
Setup>In/Out Connections menu. For example if Port1 is set for AIS 38400, the
Input and Output both operate at 38400 baud.
2.4.3.2 AIS Setup
The CPF300i has to be set up to be able to receive NMEA information from the AIS receiver.
The GPS Chart Plotter reads the AIS NMEA message VMD, type 1, 2, 3 and 5 for AIS Class
A and type 18, 19, 24 for AIS Class B. Select the used serial port and transmission speed
by following the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
Page 24
Optional WAAS GPS
antenna
PWR & ACC 1 Cable
Optional WAAS GPS
antenna
Red
Black
Blue
Brown
Gray
Yellow
NOTE
Red
Switch
Black
2A
Fuse
Switch
2A
Battery
Fuse
10-35Vdc
Port 1 Input
Port 1 Output
Port 2 Input
Port 3 Output
CPF180i and CPF300i
-
+
Battery
10-35Vdc
-
+
VHF
AIS
PILOT
Advertisement
Table of Contents
