Cpf300I Connection Table - Standard Horizon CPF180i Owner's Manual

Optional WAAS GPS
antenna
CPF180i
Transducer
2.4.1.2 AIS Setup
The CPF180i has to be set up to be able to receive NMEA information from the AIS receiver.
The GPS Chart Plotter reads the AIS NMEA message VMD, type 1, 2, 3 and 5 for AIS Class
A and type 18, 19, 24 for AIS Class B. Select the used port and transmission speed by
following the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT1 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
If an AIS receiver is not connected, Port1 Input can be connected to most DSC VHF's for position polling.
The Input and Output baud rate for each port is set using the Advanced Setup>In/Out Connections
menu. For example if Port1 is set for AIS 38400, the Input and Output both operate at 38400 baud.
2.4.2

CPF300i Connection Table

12VDC Power
Pin Wire Color Description
1 Black Battery Ground &
Common for
NMEA devices*
2 Red Battery Positive
3 Green Port3 Input
4 Blue Port1 Input
5 Brown Port1 Output
6 Gray Port2 Input
7 White Port2 Output
8 Yellow Port3 Output
CPF180i and CPF300i
Red
Black
Green
Blue
Brown
Yellow
PWR & ACC 1 Cable
NOTE
NOTE
Connection Example
Connect to Battery Ground and
and signal ground
Connect to Battery Positive
Connect to Output of NMEA devices*
Connect to Output of NMEA devices*
Connect to Input of NMEA devices*
Connect to Output of NMEA devices*
Connect to Input of NMEA devices*
Connect to Input of NMEA devices*
Switch
-
+
2A
Battery
Fuse
10-35Vdc
NMEA Common
VHF
Port 1 Input
Port 1 Output
Port 3 Output
Additional Comments
Default is NMEA0183
Default is NMEA0183
Default is NMEA0183 with GGA, GLL, RMC,
XTE, DBT, DPT, MTW, VHW sentences
Default is NMEA0183
Default is NMEA0183 with GGA, GLL, RMC
and XTE sentences
Default is NMEA0183 with APA, APB, BOD,
GGA, GLL, RMC and BOD sentences
PILOT
Page 23