Sleep Mode Network Settings; Configuring Sleep Mode Settings; Sleep Mode Network Settings Advanced - Xerox ColorQube 9301 System Administrator Manual

Network Configuration

Sleep Mode Network Settings

You can allow the printer to poll Novell print queues and broadcast Service Advertising Protocol (SAP)
during sleep mode.

Configuring Sleep Mode Settings

1. In CentreWare Internet Services, click Properties > General Setup.
Click Sleep Mode Settings.
2.
3. To allow the printer to poll Novell print queues, select Resume Network Controller Briefly to Poll
Novell Print Queues During Sleep Mode.
4. Type the time in seconds to define the interval the printer uses to come out of Sleep Mode.
5. To allow the printer to broadcast SAP during sleep mode, select Resume Network Controller Briefly
to Broadcast Service Advertising Protocol (SAP) During Sleep Mode.
6. Type the time in seconds to define the interval the printer uses to come out of Sleep Mode.
Click Apply to save the new settings or Undo to retain the previous settings.
7.
See also:
NetWare on page 23.

Sleep Mode Network Settings Advanced

You can allow the printer to respond to four types of broadcast packets during sleep mode.
Notes:

Some printers do not support this function.

If the printer is using an IPv6 Link-Local address, enabling the IPv6 ND multicast filter brings
the printer out of sleep mode.
Configuring Advanced Sleep Mode Settings
1. In CentreWare Internet Services, click Properties > General Setup.
2. Click Sleep Mode Settings > Advanced Settings.
In the Packet Priority list, click the Increase Priority and Decrease Priority buttons to prioritize the
3.
packet types.
Click Apply to save the priority list.
4.
The printer processes the list and displays the top four packet types if the corresponding protocols
have been enabled. Packet types that do not have the corresponding protocol enabled are skipped.
5. Click Return to return to the Sleep Mode Settings page.
56 ColorQube 9301/9302/9303 Multifunction Printer
System Administrator Guide