Xerox ColorQube 9301 System Administrator Manual page 82

Multifunction printer
Hide thumbs Also See for ColorQube 9301:
Table of Contents

Advertisement

Security
Configuring Manual Keying Settings
Manual Keying is used when client systems either do not support IKE or are not configured for IKE.
1.
Under IPsec Mode, select Transport Mode or Tunnel Mode.
Note:
Transport mode only encrypts the IP payload, whereas Tunnel mode encrypts the IP header
and the IP payload. Tunnel mode provides protection for an entire IP packet by treating it as an
Authentication Header (AH), or Encapsulating Security Payload (ESP).
2.
If you selected Tunnel Mode, under Enable Security End Point Address, select the address type.
Options are Disabled, IPv4 Address, or IPv6 Address.
3.
Under IPsec Security, select ESP, AH, or BOTH.
4.
In the Security Parameter Index: IN field, type a 32-bit number larger than 256 that identifies the
inbound Security Association (SA).
5.
In the Security Parameter Index: OUT field, type a 32-bit number larger than 256 that identifies the
outbound Security Association (SA).
6.
Under Hash, select from the following:
SHA1
None
Under Enter Keys as, select ASCII format or Hexadecimal number.
7.
8.
Type a 20-character ASCII key, or 40-character Hexadecimal key for the following:
Hash Key: IN
Hash Key: OUT
9.
If you selected ESP or BOTH for the IPsec Security type, select one or more of the following
Encryption types:
Note:
If the IPsec Security type is set to AH, the Encryption type options do not appear.
AES
3DES
None
10. Type a 24-character ASCII key, or 48-character Hexadecimal key for the following:
Encryption Key: IN
Encryption Key: OUT
11. Click Save to apply the new settings or Undo to retain the previous settings.
Configuring Internet Key Exchange Settings
IKE is a keying protocol that allows automatic negotiation and authentication, anti-replay services, and
CA support. It can also change encryption keys during an IPsec session. IKE is used as part of virtual
private networking.
IKE Phase 1 authenticates the IPsec peers and sets up a secure channel between the peers to enable IKE
exchanges. IKE Phase 2 negotiates IPsec SAs to set up the IPsec tunnel.
82
ColorQube 9301/9302/9303 Multifunction Printer
System Administrator Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Colorqube 9302Colorqube 9303

Table of Contents