Relay Activation Check; Remote Programming; Remote Relay Activation - DKS 1812 Owner's Manual

4.11

Relay Activation Check

The 1812 can be called to check if relay 1, relay 2, or both relays in the system are latched and
holding a door or gate in the open (unlocked) position.
1. Pick up your telephone and press * 7 (beep).
2. Listen for the following sequence of tones. No tones: neither relay is activated. Relay
1 activated: beep - pause - beep - pause . . .Relay 2 activated: beep beep - pause -
beep beep - pause . . .Both relays activated: beep beep beep - pause - beep beep
beep - pause . . .
3. Hang up.
4.12

Remote Programming

The 1812 can be programmed from a remote location using a touch-tone telephone. The auto answer
feature must be turned on (4.10) to perform any remote programming. The 1812 master code cannot
be programmed remotely.
1. Call the residents phone number. After the programmed number of rings (2.3.6) the 1812
will answer with a tone (beep).
2. Follow the desired programming steps in programming section of this manual.
3. When complete with the desired programming section, hang up. You cannot use 0# to
end programming steps from a touch-tone telephone.
4.13

Remote Relay Activation

The 1812 system relays can be activated from the house or from a remote (off site) location. The auto
answer feature must be turned on (4.10) to activate any of the relays from a remote location.
To activate the relay(s) from the resident's house, perform the following steps.
1. Pick up your telephone and press * 7 (beep).
2. Enter the desired tone open number _ (beep).
3. Hang up.
To activate the relay(s) from a remote (off-site) location, perform the following steps.
1. Call the residents phone number. After the programmed number of rings (2.3.6) the
1812 will answer with a tone (beep).
2. Press * 1 6 .
3. Enter the four-digit MASTER CODE _ _ _ _ (beep).
4. Enter the desired tone open number _ (beep).
5. Hang up.
39