2.3 GENERAL PROGRAMMING
Proceed with the programming steps on the following pages if PC programming will not be used.
2.3.1 Relay Strike Time
These steps will program Relay 1 and Relay 2 strike times. Strike times can be programmed from 1/4
second (enter 00 in step 4) up to 99 seconds by entering the desired time in seconds.
1.
Press * 0 3 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Press 1 * (beep) to set relay 1, or 2 * (beep) to set relay 2 strike time.
3.
Enter the two-digit strike time _ _ (00-99) then press * (beep).
4.
Repeat steps 2 and 3 to set other relay strike time.
5.
Press 0# TOGETHER to end this programming step (beeeeeep).
2.3.2 Tone Open Numbers
These steps will program the tone open number(s) for both relay 1 and relay 2. Each relay is
programmed independently. You will need to enter a four-digit number (see chart below) to set each
relay. If a function is not desired, enter # in place of a number. For example, if you want the relay to
have a momentary activation function only, and you want the relay to activate when the number 9 is
pressed, enter 9 # # # in step 4.
1.
Press * 0 5 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Press 1 * (beep) to set relay 1, or press 2 * (beep) to set relay 2.
3.
Enter the four-digit tone open number code _ _ _ _ then press * (beep).
4.
Repeat steps 3 and 4 to set the other relay tone open number(s).
5.
Press 0# TOGETHER to end this programming step (beeeeeep).
Digit
Step 3
1 st
Momentary activation. The relay will activate for its programmed strike time.
2 nd
Hold open. The relay will activate and remain activated until commanded to deactivate.
3 rd
Deactivate relay.
4 th
Hold open 1 hour. The relay will activate for 1 hour and then deactivate itself.
Function
25