Ejecting Single Sheets; Using Continuous Forms - Fujitsu DL7400 User Manual

PAPER HANDLING
USING
CONTINUOUS
FORMS
3-14
•
Load the paper manually. Press the LOAD button. The
paper will advance to the top-of-form position. Adjust the
position of the paper as needed by the
the MICRO button (micro feed).
•
Load the paper using your software. Press the ONLINE
button to place the printer online. Load paper according to
the instructions in your software documentation. Most
software packages load paper automatically.
After loading paper, the printer goes into online mode.
7. Print a sample page and check the page margins. Make the
following adjustments, as necessary:
•
Horizontal alignment. Readjust the paper guides if required.
•
Top-of-form setting (see Chapter 5).
•
Margin settings. Use your software or the printer setup
mode (see Chapter 5).
NOTE
Do not open the front cover during printing.

Ejecting Single Sheets

If you print using software, each sheet is ejected automatically when the
end of the printed page is reached. To manually eject sheets of paper, use
the following method:
•
Press and hold down the LF/FF button to execute a forward
form feed.
Continuous forms paper, fanfolded at the horizontal perforations, is ideal
for printing rough drafts and long files. The paper is fed into the printer
using the forms tractors.
MICRO button or
User's Manual