Fujitsu DL7400 User Manual page 130

USING SETUP MODE
5-40
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
Options
CONFIG
Items
<TEAR-EN>
(continued)
<CUTLOAD>
AUTO
BUTTON
The following <LOADTIM> item is printed when CUTLOAD:AUTO
is specified for the <CUTLOAD> item.
<LOADTIM>
0.5, 1.0, 1.5,
2.0 2.5,
3.0SEC
<DECODE>
DIRECT
QUEUED
Description
In some application
programs, data
transfer may stop temporarily due to
internal processing. This setting can
avoid an undesired tearoff feed by
waiting for up to six seconds each
time data transfer stops.
Single sheet autoloading.
Single sheet paper is automatically
loaded a certain time after you set the
paper.
Single sheet paper can be loaded by
pressing the LOAD button.
Autoload start time.
Autoloading starts when this amount
of time passes after you set single
sheet paper.
Command decode timing.
The printer decodes certain
commands immediately after
receiving data.
Example:
ESC SUB I, ESC CR
P (DPL24C+) ESC
Q # (IBM XL24E)
The printer decodes commands after
storing all data (including commands)
in the input buffer. This speeds data
reception because the printer does not
require decoding time during data
reception.
User's Manual