Fujitsu DL7400 User Manual page 136

USING SETUP MODE
5-46
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
Options
CONFIG
Items
<RL-CENT>
POSN1
POSN2
<SKEWCNT>
ENABLE
DISABLE
<FF-CODE>
EJECT
FORM-FD
<PRT-CUT>
71/180
99/180
<CSFBIN1>
FRONT
REAR
Description
Selection of the print carrier position
when paper is fed via a front path (with
feeding of continuous forms paper from
the rear and use of a rear CSF)
Position 1: Column 31
Position 2: Column 42
Detection of paper feed skew
Enables paper feed skew detection.
Disables paper feed skew detection.
Selection of the method of processing
for the FF code is received in cut sheet
mode or for the "LF/FF" switch
Ejects cut sheets.
Uses a page break.
Selection of the cut amount (margin) on
both sides of continuous forms paper
when AREACNT, the cut amount in
continuous printing, is set to ENABLE
Sets the cut amount for printing to
71/180 inches (about 10.0 mm).
Sets the cut amount for printing to
99/180 inches (about 14.0 mm).
Selection of the CSF for bin 1 if both a
front CSF and rear CSF are mounted
Front CSF
Rear CSF
User's Manual