Fujitsu DL7400 User Manual page 62

PAPER HANDLING
PRINT
MODE/
FRONT DIR
AUTO GAP
MANUAL
GAP DIAL
3-4
Table 3.1 Buttons Used for Paper Handling (Cont.)
Button/Dial Purpose
Select cut
sheet ejection
MICRO Micro Feed
MICRO
Select paper
thickness
control mode
Select paper
Thickness at
MANUAL
MODE
Action
Press PRINT MODE/FRONT DIR at Offline to
select a direction of ejecting cut sheet.
• Front ejection – FRONT indicator lights. It
blinks when paper is ejected to
the paper table prompting the
user to remove the paper.
• Rear ejection – FRONT indicator does not
light.
When you save your setting in the setup mode, it
becomes the new default. The default setting is
invoked whenever you turn on the printer.
Press MICRO/ MICRO to feed paper by 1/180
inch in the direction of the arrow.
Select paper thickness control mode.
AUTO GAP — AUTO GAP indicator lights.
Manual Gap — AUTO GAP indicator doesn't
lights.
The Manual Gap dial is enabled.
Select the paper thickness at MANUAL MODE.
Auto Gap is usually used. Auto Gap is used for
printing on paper of different thicknesses.
User's Manual