Fujitsu DL7400 User Manual page 137

User's Manual
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
Options
CONFIG
Items
<CNT-LD>
PRCISIN
SPEED
<CSF-LD>
NORMAL
SWBACK
<CSFAPTC>
ALWAYS
NORMAL
<LF-CTL>
PRCISIN
SPEED
<PR-MODE>
NORMAL
QUIET
<HI-IMPT>
DISABLE
ENABLE
USING SETUP MODE
Description
Selection for the paper feeding of
continuous forms paper
Gives a higher priority to precision.
Gives a higher priority to speed.
Selection of the method of feeding
from the CSF
Feeds paper directly from the CSF
hopper.
Feeds paper from the CSF hopper to
either the cut sheet table used with a
front CSF or the stacker used with a
rear CSF. Then, that paper is fed
again.
Paper thickness detection with use of
a CSF
Every sheet of paper that is fed
Sheet of paper that is fed immediately
after the feed pin is switched
Selection for LF mode
Gives a higher priority to precision.
Gives a higher priority to speed.
Selection for print mode
(standard/low noise)
Prints in standard mode.
Prints in low-noise mode.
Selection for high printing pressure
mode
Prints in standard pressure mode.
Prints in high printing pressure mode.
5-47