Ejecting Single Sheets; Using Continuous Forms - Fujitsu DL9300 User Manual

PAPER HANDLING
USING CONTINUOUS
FORMS
3-16
9. Load paper to the top-of-form position using either of the
following methods:
• Load the paper manually. Press the LOAD button. The
paper will advance to the top-of-form position. Adjust the
position of the paper as needed by the MICRO button or
the MICRO button (micro feed).
• Load the paper using your software. Press the ONLINE
button to place the printer online. Load paper according to
the instructions in your software documentation. Most
software packages load paper automatically.
After loading paper, the printer goes into online mode.
10. Print a sample page and check the page margins. Make the
following adjustments, as necessary:
• Horizontal alignment. Readjust the paper guides if re-
quired.
• Top-of-form setting (see Chapter 5).
• Margin settings. Use your software or the printer setup
mode (see Chapter 5).
NOTE
Do not open the front cover during printing.

Ejecting Single Sheets

If you print using software, each sheet is ejected automatically when
the end of the printed page is reached. To manually eject sheets of
paper, use the following method:
• Press and hold down the LF/FF button to execute a forward
form feed.
Continuous forms paper, fanfolded at the horizontal perforations, is
ideal for printing rough drafts and long files. The paper is fed into the
printer using the forms tractors.
User's Manual