Preprinted Sheets; Transparencies - Fujitsu PrintPartner 12V User Manual

Handling Paper
2-24

Preprinted Sheets

In general, you can safely print on preprinted sheets such as
letterhead. However, letterhead with thermographic (raised)
printing, embossing, or foil stamping may not work well. The forces
used to create these effects (heat and/or pressure) are also used in the
printer' s fuser unit. For this reason, the fuser unit may damage the
preprinted image.
Load preprinted paper with the printed side facing down in the
paper tray. When using the manual feed slot, place paper with the
printed side facing up. For printing in portrait orientation, the
letterhead should be at the front of the tray. For landscape
orientation, it should be at the right of the tray. For more
information on printing in different orientations, see the later section
of this chapter.

Transparencies

This printer can print on overhead transparency material.
We recommend you to set up the rear stacker so that transparencies
l
are ejected straight out the back to minimize curl.
The capacity of the rear stacker is about 20 sheets.
• Use materials specially designed for laser printers or photocopiers.
Always feed transparency material from the manual feed slot or the
l
optional multi-function feeder.
To remove curls from printed transparency materials, use correct
l
frames or put a weight on them until they lay flat.
• Be sure to fan the transparency stack to prevent sheets from
sticking together.
User' s Manual