Fujitsu DL7400 User Manual page 124

USING SETUP MODE
5-34
Table 5.5 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
Options
HARDWRE
Items
<FCUTORG> 1/6 IN
1.8/6 IN
:
6/6 IN
:
66/6 IN
<FCUTFIN>
0/180, ..., 29/180
<RCUTORG> 1/6 IN
1.8/6 IN
:
6/6 IN
:
66/6 IN
<RCUTFIN>
0/180, ..., 29/180
Description
Sets the top-of-form for front single
sheets in increments of 1/6 inch (4.2
mm) from the physical top of the page.
The default is recommended if your top
margin is not software-specified. A
setting of 1/6 inch is preferable when
your top margin is software-specified.
Fine-tunes the top-of-form position for
front single sheets.
Increases top-of-form in increments of
1/180 inch
(0.14 mm).
Sets the top-of-form for rear single
sheets in increments of 1/6 inch (4.2
mm) from the physical top of the page.
The default is recommended if your top
margin is not software-specified. A
setting of 1/6 inch is preferable when
your top margin is software-specified.
Fine-tunes the top-of-form position for
rear single sheets.
Increases top-of-form in increments of
1/180 inch
(0.14 mm).
User's Manual