Verifying Dial Peer Configuration For Mgcp Gateways - Cisco VGD-1T3 Software Configuration Manual

Using Cisco Unified Communications Manager to Configure MGCP Gateway Support
Command or Action
Step 6
port port/slot/DS1 port number:group
Example:
Router(config-dial-peer)# port 1/0/1:23
Step 7
exit
Example:
Router(config-dial-peer)# exit

Verifying Dial Peer Configuration for MGCP Gateways

Use the show commands described in this section to verify the dial-peer configuration for MGCP
gateways.
SUMMARY STEPS
1.
2.
DETAILED STEPS
show running-config
Step 1
Use the show running-config command to verify the dial peer configuration.
The following example shows a configuration on MGCP voice gateways for T1 CAS with e&m-fgb
emulation.
ccm-manager switchback immediate
ccm-manager fallback-mgcp
ccm-manager mgcp
!
controller T1 1/0:1
framing esf
linecode b8zs
ds0-group 1 timeslots 1-24 type e&m-fgb
!
voice-port 1/0:1:1
!
dial-peer voice 1 pots
service mgcpapp
destination-pattern 91..........
port 1/0:1:1
The following example shows a configuration on MGCP gateways for VoIP calls, when the fallback
feature is used.
dial-peer voice 555 voip
application mgcpapp
destination pattern 555...
incoming-called-number 444...
session-target ipv4:172.20.21.8
codec g711ulaw
show running-config
show dial-peer voice tag
Purpose
Binds the MGCP application to the specified voice port.
• The slot, port, DS1 port number, and group arguments
identify the specific port identification.
Exits dial-peer configuration mode and returns to global
configuration mode.
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
Configuring MGCP Gateway Support
131