Configuring The System To Perform As A Femto Network Gateway; Required Information; Required Local Context Configuration Information - Cisco ASR 5000 Series Administration Manual

Femto network gateway
Hide thumbs Also See for ASR 5000 Series:
Table of Contents

Advertisement

▀ Configuring the System to Perform as a Femto Network Gateway

Configuring the System to Perform as a Femto Network
Gateway
This section provides a high-level series of steps and the associated configuration file examples for configuring the
system to perform as an FNG in a test environment. For a configuration example without the instructions, refer to
Appendix A.
Information provided in this section includes the following:

Required Information

Femto Network Gateway Configuration
Required Information
The following sections describe the minimum amount of information required to configure and make the FNG
operational in the network. To make the process more efficient, it is recommended that this information be available
prior to configuring the system.

Required Local Context Configuration Information

The following table lists the information that is required to configure the local context.
Table 5. Required Information for Local Context Configuration
Required
Description
Information
Management Interface Configuration
Interface name
An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface will be
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
IP address and
The IPv4 address assigned to the interface.
subnet mask
Multiple addresses and subnet masks are needed if multiple interfaces will be configured.
Physical Ethernet
The physical Ethernet port to which the interface will be bound. Ports are identified by the chassis slot
port number
number where the line card resides followed by the number of the physical connectors on the card. For
example, port 24/1 identifies connector number 1 on the card in slot 24.
A single physical port can facilitate multiple interfaces.
Gateway IP address
Used when configuring static IP routes from the management interface(s) to a specific network.
▄ Cisco ASR 5000 Series Femto Network Gateway Administration Guide
36
Femto Network Gateway Configuration
OL-24872-01

Advertisement

Table of Contents
loading

Table of Contents