3: Layer Dry Output Select - Yamaha SY85 Owner's Manual

3: LAYER DRY OUTPUT SELECT

[PERFORMANCE] → [EFFECT EDIT] → [MENU] → 3:Layer Dry Out Select → [ENTER/YES]
passes each effect processor) on or off, determining whether any dry signal output
can occur at OUTPUT 1 and OUTPUT 2.
Layer
Dry1
Dry2
40
PERFORMANCE EDIT MODE /
These parameters determine turn the "dry lines" (i.e. the signal paths which by-
OUTPUT`Select`<InitVce`>`Dry1`Dry2`
``Layer=A(¡A1)`````````````on```on
F1 F2
CS1 CS2
Range: A, B, C, D
Controls: [CS2], PROGRAM [1] ... [4], [-1] [+1], Dial
Selects the layer to be edited. The name of the voice assigned to the se-
lected layer is shown between parentheses on the upper line of the display.
Range: off, on
Controls: [CS6], [-1] [+1], Dial
Turns the "dry line" bypassing the EFFECT 1 signal processor on or off.
When this parameter is turned "off," the "WET:DRY BALANCE" parameters
(page 42) have no effect.
Range: off, on
Controls: [CS7], [-1] [+1], Dial
Turns the "dry line" bypassing the EFFECT 2 signal processor on or off.
When this parameter is turned "off," the "WET:DRY BALANCE" parameters
(page 42) have no effect.
EFFECT EDIT
F3 F4 F5
CS3 CS4 CS5
F6 F7 F8
CS6 CS7 CS8