Yamaha SY85 Owner's Manual page 302

SAVE operation saves MDR data from the internal memory to the specified disk file
number, and a LOAD operation loads MDR data to the internal memory from the
specified disk file number.
230
UTILITY MODE /
2: MDR SAVE/LOAD
This utility is used to move MDR data between the internal memory and disk. A
MDR````````````<--NEW--*>```````````````
[LOAD]SAVE```````Disk=01``¥`Internal````
F1 F2
CS1 CS2
Press the [F1] key to highlight "LOAD" on the display if you want to load
MDR data from the disk into the SY85 internal memory, or press the [F2] key
to highlight "SAVE" on the display if you want to save MDR data from the
internal memory to the disk. Next, use [CS5] to select the number of the disk
file (00 through 99) that you want to load from or save to.
Press [ENTER/YES] to begin the MDR disk load or save procedure. If you
select "SAVE", you have the option of pressing the [F2] key to give the data
file a name before it is saved (the name is displayed above the file number —
unnamed files are automatically named "--NEW--*"). If you choose the
"NAME" option, enter the file name in the normal way (see page 95), then
press [ENTER/YES] to begin the disk load or save procedure. The following
confirmation display will appear:
MDR````````````<--NEW--*>`Are`you`sure`?
[LOAD]SAVE```````Disk=01``¥`Internal````
Press [ENTER/YES] again to confirm that you want to go ahead with the
disk load or save operation, or press [EXIT/NO] to cancel.
When the data has been loaded or saved, "Completed!" will appear briefly
on the display.
See page 321 for information on disk error messages.
DISK
F3 F4 F5
CS3 CS4 CS5
F6 F7 F8
CS6 CS7 CS8