6: Send & Effect 2 Mix Level - Yamaha SY85 Owner's Manual

6: SEND & EFFECT 2 MIX LEVEL
[PERFORMANCE] → [EFFECT EDIT] → [MENU] → 6:Mix Level → [ENTER/YES]
These parameters determine the mix level between each effect send and the output
of the preceding effect stage. Refer to the section beginning on page 254 for details
on the overall SY85 effect system.
EF`Mix`Level```EF2``Insert`1b```2a```2b`
````````````````--`````````--```--````0%
EF2 Mix (Effect 2 mix level)
Insert 1b, 2a, 2b (Insert level)
F1 F2 F3
CS1 CS2 CS3
Range: 0 ... 100
Controls: [CS4], [-1] [+1], Dial
Mixes the output of the EFFECT 2 processor with that of the EFFECT 1
processor. This parameter can only be used with the "serial" effect mode is
selected. If any other mode is selected ("off" or "para"), "---" appears on the
display in place of the value.
If a controller is assigned to the EF2 Mix parameter (page 45), an inverse
"c" will appear to the right of the parameter.
Range: 0 ... 100
Controls: [CS6], [CS7], [CS8], [-1] [+1], Dial
These parameters mix the dry signal sent to the corresponding effect stage
with the output of the preceding effect stage. The higher the value the greater
mix level. If the current effect configuration does not allow one of these mix
parameters, "--" will appear in place of the mix level parameter.
If a controller is assigned to the one of these parameters (page 45), an
inverse "c" will appear to the right of the parameter.
F4 F5 F6
CS4 CS5 CS6
PERFORMANCE EDIT MODE /
F7 F8
CS7 CS8
EFFECT EDIT 43