4: Performance Initialize - Yamaha SY85 Owner's Manual

4: PERFORMANCE INITIALIZE

[PERFORMANCE] → [JOB] → [MENU] → 4:Initialize → [ENTER/YES]
When you want to program a totally new performance combination "from
scratch," rather than editing an existing combination, use this function to initialize all
performance parameters.
PERFORMANCE`JOB`Initialize``
`````````````````````````[EDIT]`LYR
F1 F2 F3
CS1 CS2 CS3
Press [F6] if you want to initialize the entire performance combination
currently in the edit buffer, or [F7] if you only want to initialize one specific
layer. If you choose [F7], use the [CS8] slider to select the layer you want to
initialize.
Press [ENTER/YES] to begin the initialize procedure. The following confir-
mation display will appear:
PERFORMANCE`JOB`Initialize
Are`you`sure`?```````````[EDIT]`LYR
Press [ENTER/YES] again to confirm that you want to go ahead with the
initialize operation (which will erase all current edited data), or press [EXIT/
NO] to cancel.
When the performance data has been initialized, "Completed!" will appear
briefly on the display, then the display will return to the mode that was en-
gaged prior to calling the performance initialize function.
F4 F5 F6
CS4 CS5 CS6
PERFORMANCE EDIT MODE /
F7 F8
CS7 CS8
JOB 53