Yamaha SY85 Owner's Manual page 37

Respond to "Are you sure?" on the display by pressing the [ENTER/YES]
key again. "Completed" will appear for a few seconds when the initialization
job has finished.
PERFORMANCE`JOB`Initialize``````````````
```Completed`!```````````[EDIT]`LYR`````
3.
Select the Performance Edit "LAYER" Mode
k
Press the SUB MODE [EDIT] key. This selects the performance edit mode.
Use the PAGE [ ] and [
doesn't appear immediately).
LAYER```````````````````````````````````
`````````````````````````````Hit`[ENTER]
When you've located this screen, press [ENTER/YES] to engage the per-
formance edit LAYER mode.
4.
Select the Voices for Each Layer
If the "LAYER Voice Number" display doesn't appear as soon as you
engage the performance edit mode, press the PAGE [
it does appear (see the "HINT", below).
LAYER`Voice`Number````````<SP`Makro>ABCD
````A=¡A1`````B=¡A1`````C=¡A1`````D=¡A1`
The voice numbers assigned to each layer are shown across the bottom of
the display. After initialization, voice "I
Press the [F2] function key to place the underline cursor under the layer-A
voice number (note that the voice name is shown between parentheses in the
upper right corner of the display), then use the [CS2] control slider or any of
the voice selection methods already described to select voice number "I
(BA Wood).
Next press the [F4] function key to select the layer-B voice number, and
use the [CS4] control slider or any other voice selection method to select voice
number "I B1" (AP Grand).
I
Next press the [F6] function key to select the layer-C voice number, and
use the [CS6] control slider or any other voice selection method to select voice
number "I D1" (ST Power).
I
Finally, press the [F8] function key to select the layer-D voice number and,
while holding the [SHIFT] key, press the [-1] key to turn layer-D "off".
l
] keys to select the "LAYER" entry screen (if it
A1" is assigned to all four layers.
I
3. The Performance Mode
k
] key a few times until
C1"
I
35