Bulk Dump; `````````````1`:All; 2: Synth All; 3: Sequencer All - Yamaha SY85 Owner's Manual

[UTILITY] → [MIDI]
data.
Type
222
UTILITY MODE /

BULK DUMP

Initiates MIDI bulk transmission of the selected voice, multi-play, and/or system
Bulk`Dump````Type```````````````````````

`````````````1`:all

F1 F2
CS1 CS2
Range: all, synth all, sequencer all, pattern all, 1 performance, 1
voice, 1 song
Controls: [CS3], [-1] [+1], Dial
Use [CS3] to select the type of data you want to transmit. The various data
types are as follows:
1: all

2: synth all

3: sequencer all All sequencer data, including setup, songs,and patterns.

4: pattern all

5: 1 performance The currently selected performance combination.

6: 1 voice

7: 1 song

Press [ENTER/YES] to begin the bulk dump procedure. The following
confirmation display will appear:
Bulk`Dump````Type`````````Are`you`sure`?
`````````````1`:all
Press [ENTER/YES] again to confirm that you want to go ahead with the
bulk dump operation, or press [EXIT/NO] to cancel.
When the data has been transmitted, "Completed!" will appear briefly on
the display.
This function is useful for transferring synthesizer, sequencer, and/or system
data from one SY85 to another. If the MIDI OUT of the transmitting SY85 is
connected to the MIDI IN of the receiving SY85 via a MIDI cable, the receiv-
ing unit will automatically receive and load the data as long as its BULK
RECEIVE PROTECT (page 214) function is turned "off" and it is set to the
same device number as the transmitting SY85. Another possibility is to transfer
the data to an external MIDI bulk data storage device for long-term storage.
MIDI
F3 F4 F5
CS3 CS4 CS5
All internal data.
All synthesizer data, including setup, performance
combinations, and voices.
All patterns.
The currently selected voice.
The currently selected song, including multi data.
F6 F7 F8
CS6 CS7 CS8