4: Output Level - Yamaha SY85 Owner's Manual

[VOICE] → [EFFECT EDIT] → [MENU] → 4:Output Level → [ENTER/YES]
separate output levels that are adjusted by the parameters provided in this screen.
1a, 1b, 2a, and 2b (Effect output levels)
132
DRUM VOICE EDIT MODE /

4: OUTPUT LEVEL

Depending on the selected effects the SY85 effect system can have up to four
EF`OutLevel`1a```1b`````````````2a```2b`
`EF1(sngl)=100%``--``EF2(sngl)=`98%``--
F1 F2
CS1 CS2
Range: 0 ... 100
Controls: [CS3], [CS4], [CS7], [CS8], [-1] [+1], Dial
The [CS3] and [CS4] sliders adjust the output levels of the effect 1 "1a"
and "1b" stages, respectively, while the [CS7] and [CS8] sliders adjust the
output levels of the effect 2 "2a" and "2b" stages. A setting of "0" turns output
from the corresponding effect stage off, while a setting of "100" produces
maximum output level.
If the selected effect is a "single" type, then only the "1a" or "2a" output
level is available. If it is a "cascade" type, then only the "1b" or "2b" output
level is available. Both the "1a" and "1b" or "2a" and "2b" levels are available
only if the selected effect is a "dual" type. The type of the effects currently
selected for the effect 1 and effect 2 processors are shown in parentheses on
the bottom line of the display. See page 254 for details on the effect stages and
the SY85 effect system in general.
If a controller is assigned to any of the output level parameters (page 136),
an inverse "c" will appear to the right of the parameter.
EFFECT EDIT
F3 F4 F5
CS3 CS4 CS5
F6 F7 F8
CS6 CS7 CS8