Quick Edit; 1: Amplitude Eg Offset - Yamaha SY85 Owner's Manual

1: AMPLITUDE EG OFFSET

[PERFORMANCE] → [QUICK EDIT] → [MENU] → 1:AEG Offset → [ENTER/YES]
These parameters allow the amplitude envelopes of the voices assigned to each
layer to be modified to some degree. The actual amplitude EG of the voices are not
affected, these "offset" values are only effective in the performance mode.
QED`AEG)````R1``R2,3``R4```RR``Vel
`ALL[Lyr:A]`+0```+0```+0```+0```+0
R1 (Attack rate)
R2,3 (Decay 1 rate)
R4 (Decay 2 rate)
F1 F2 F3
CS1 CS2 CS3
Use PROGRAM keys [1] through [4] (LAYER SELECT A, B, C, and D) to
select the layer to be edited.
Hold the [F1] function key ("ALL") while editing any of the following
parameters to change its value by the same amount for all layers simultane-
ously.
Range: -63 ... +63
Controls: [CS3], [-1] [+1], Dial
Modifies the "R1" parameter of the voice amplitude EG — see page 60.
Plus (+) values produce a faster attack rate while minus (-) values produce a
slower attack rate.
No matter how much offset is applied, the minimum and maximum EG
attack rates cannot be exceeded.
Range: -63 ... +63
Controls: [CS4], [-1] [+1], Dial
Modifies the "R2" and "R3" parameters of the voice amplitude EG — see
page 60. Plus (+) values produce a faster decay rate while minus (-) values
produce a slower decay rate.
No matter how much offset is applied, the minimum and maximum EG
decay rates cannot be exceeded.
Range: -63 ... +63
Controls: [CS5], [-1] [+1], Dial
Modifies the "R4" parameter of the voice amplitude EG — see page 60.
Plus (+) values produce a faster decay rate while minus (-) values produce a
slower decay rate.
No matter how much offset is applied, the minimum and maximum EG
decay rates cannot be exceeded.
F4 F5 F6
CS4 CS5 CS6
PERFORMANCE EDIT MODE /
F7 F8
CS7 CS8

QUICK EDIT

27