Media, cont.
Tickets with Black Mark
a
e
f
g
c
d
TICKETS
FEED
DIRECTION
Intermec EasyCoder F2 – User's Guide
⇐ a ⇒ Media Width:
Maximum:
Minimum (standard):
Minimum (Quick-Load):
⇐ b ⇒ Copy Length:
Minimum:
Maximum:
⇐ c ⇒ LSS Detection Position:
b
Five fi xed positions (distance from inner edge of the media):
3 mm
8 mm
12 mm
16 mm
20 mm
⇐ d ⇒ Black Mark Width:
The detectable width of the black mark should be at least 5.0
mm (0.2 inches) on either side of the LSS detection point.
⇐ e ⇒ Black Mark Length:
Maximum:
Common:
Minimum:
⇐ f ⇒ Black Mark Y-Position:
It is recommended that you place the black mark as close to
the front edge of the ticket as possible and use a negative Stop
Adjust value to control the media feed, so the tickets can be
properly torn off.
Media Type Setup:
• Mark
The black mark should be non-refl ective carbon black on a whitish
background. Do not allow any perforations to break the edge of the
media as this may cause the media to split and jam the printer.
Appendix 2 Media Specifi cations
(0.118 inches)
(0.315 inches)
(0.472 inches)
(0.639 inches)
(0.787 inches)
60.0 mm
(2.36 inches)
25.0 mm
(1.00 inches)
40.0 mm
(1.57 inches)
20.0 mm
(0.8 inches)
depends on DRAM size
21.3 mm
(0.83 inches)
12.5 mm
(0.5 inches)
5.0 mm
(0.2 inches)
73