Tickets With Black Mark - Intermec EasyCoder PX6i User Manual

Tickets with Black Mark

⇐ a ⇒ Media Width
Maximum:
Minimum:
⇐ b ⇒ Copy Length
Maximum:
provided there is a suffi cient amount of free SDRAM memory
Minimum:
⇐ c ⇒ LSS Detection Position
Variable, see Chapter 11.
⇐ d ⇒ Black Mark Width
Maximum:
Recommended:
Minimum:
⇐ e ⇒ Black Mark Length
Maximum:
Common:
Minimum:
⇐ f ⇒ Black Mark Y-Position
It is recommended that you place the black mark as close to the front
edge of the ticket as possible. The black mark can be placed either on the
top or at the back of the media.
Black Mark Characteristics
Maximum refl ectance:
Difference between mark and media:
Media Type Setup
• Ticket (w mark)
Note: Do not allow any perforations to break the edge of the
media as this may cause the media to split and jam the printer.
EasyCoder PX6i User's Guide (IPL version)
Appendix B — Media Specifi cations
170 mm (6.69 inches)
76 mm (3.00 inches)
6,143 mm (241 inches)
20.0 mm (0.8 inches)
Full media width
10.0 mm (0.39 inches)
5.0 mm (0.20 inches)
25.0 mm (0.98 inches)
3.2 mm (0.13 inches)
1.27 mm (0.05 inches)
15%, 940 nm
55%
107