Setting Up The Printer; Description; Default Setup - Intermec EasyCoder F2 User Manual

Chapter 6

Setting Up the Printer

Description

Default Setup

34
The setup controls the printer in regard of serial communication,
test and service operations, and specifi es which types of media
and ribbon are loaded in the printer.
Check the list below to see if the printer's default setup matches
your requirements. If not, you will have to change the setup. To
enter the Setup Mode, press the <Setup> key on the printer's
built-in keyboard and follow the instructions in Chapter 7,
"Setup Mode."
The printer is, by default, set up according to the list below:
Ser-Com
Baud rate:
Character length:
Parity:
Stop bits:
Protocol:
Test/Service
Testprint:
Data dump:
Memory reset:
Label rest dots:
Form adj dots X:
Form adj dots Y:
Media
Media type:
Paper type:
Label length:
Sensitivity:
Darkness:
Emulation:
9600 bps
8 bits
None
1 bit
XON/XOFF
not applicable
No
not applicable
0
0
0
Gap
DT
1200 dots
420
0%
none
Intermec EasyCoder F2 – User's Guide