Table of Contents
Advertisement
FreeBSD Driver Support
for FreeBSD 7.0-RELEASE
ok load hptiop.ko
for FreeBSD 7.0-AMD64-RELEASE
ok load hptiop.ko
5.
After the driver has been loaded, remove the floppy diskette from the floppy
drive.
6.
Type in "boot" and continue the installation as normal. You can refer to FreeBSD
installation guide.
ok boot
Note: On some systems with ACPI enabled, FreeBSD may not work. You can try to
disable ACPI in system BIOS or type the command "set hint.acpi.0.dis-
abled="1"" under boot prompt to solve the problem.
FreeBSD 7.0 and later version natively support RR3xxx/4xxx, but you still need
to load the driver manually.
For FreeBSD 4.x/5.x/6.x version: On the driver disk, there is a setup script "postinstall"
which will do this work for you. Before you reboot the system, press Alt-F4 to the
command shell and type the following commands:
# mount –o ro /dev/fd0 /mnt
# sh /mnt/postinstall
# umount /mnt
For FreeBSD 7.x version: press Alt-F4 to the command shell and type the following
commands:
# echo 'hptiop_load="YES"' >>/boot/defaults/loader.conf
Then press Alt-F1 to return to the setup screen and choose [X Exit Install] to finish
setup.
7-5
Hide quick links:
Advertisement
Table of Contents
