Installing The Rocketraid 4320 Host Adapter - HighPoint RocketRAID 4320 User Manual

J16
This connertor supports SAF-TE interface(I2C).
Pins defined as follow:
Pin 1: SCL; Pin 2: GND ; Pin 3: SDA.
J14 (BBU connector)
Connector for HPTBBU-03. (optional part).
BEEP1 – Speaker
Alarm (speaker): the speaker emits and audible alarm in the case of disk/array failure.
Ethernet Port
Ethernet port for Out of Bound Management, support Net Time Protocol.
Cable – Internal Mini-SAS to Mini-SAS
The integrated RocketRAID 4320 include 2 Internal Mini-SAS to Mini-SAS cables,
each of the cable can support 4 SAS hard disks.

2 - Installing the RocketRAID 4320 Host Adapter

Note: Make sure the system is powered-off before installing the RocketRAID 4320
host adapter.
1. Open the system chassis and locate an unused PCI-E x8 or x16 slot.
2. Remove the PCI slot cover.
3. Gently insert the RocketRAID 4320 into the PCI-E slot, and secure the bracket to
the system chassis.
4. After installing the adapter, attach the Mini-SAS connectors to the RocketRAID
4320's Mini-SAS port,and to chassis backplane. Each Mini-SAS cable supports
up to 4 hard disk drives. Consult the chassis's manual for proper installation
procedures.
5. Close and secure the system chassis.
RocketRAID 4320 Hardware Description/Installation
2-2