Table of Contents
Advertisement
Linux Driver Support
dosutils). Just run it under a command window and follow its prompt.
On a Linux system, you can use the "dd" command to make the boot diskette. Insert a
floppy disk into the floppy drive and type the command (amd64 driver for example):
# dd if=rr3xxx_4xxx-rhel_centos-.img of=/dev/fd0
Step 4 Install Red Hat Enterprise Linux/CentOS
1. Start installing Red Hat Enterprise Linux/CentOS by booting from the installation
CD.
2. On "Welcome to Red Hat Enterprise Linux/CentOS" installation screen, a
prompted label "boot:" will appear at the bottom of the screen: For RedHat
Enterprise Linux 3, type in "expert text" (without quotation mark);
For RedHat Enterprise Linux 4 and its update version, type in "linux dd" (without
quotation mark),
For RedHat Enterprise Linux 5, type in "linux dd updates" (without quotation
mark), then press Enter. Do not remove the floppy diskette until installation
completed.
3.
When prompted "Do you have a driver disk?". Select "Yes".
4.
When prompted "Insert your driver disk and press OK to continue", insert the
driver diskette in the floppy drive and then select "OK".
5. The system will load RR4320 driver automatically. Continue the installation as
normal.
6.
When asked "where do you want to install the boot loader? " in the "Boot Loader
Configuration" dialog, you must select "Master Boot Record (MBR)" to make
your system be able to boot RR4320 controller.
7. Continue the installation as normal. You can refer to Red Hat Enterprise Linux/
CentOS installation guide.
Note
1.
The system device mapping order is the same as the order shown in RR4320
BIOS Setting Utility.
6-15
Hide quick links:
Advertisement
Table of Contents
