Table of Contents
Advertisement
Note:
1.
The system device mapping order is the same as the order shown in RR4320
BIOS Setting Utility.
2. On some system the LILO boot loader may be installed incorrectly unless you
specify BIOS parameters in /etc/lilo.conf. During installation, when prompted
"Would you like to create a boot disk for your system?", switch to console 2 by
pressing <Ctl>+<Alt>+F2. Then use the following command:
# chroot /mnt/sysimage
# vi /etc/lilo.conf
Add two lines under the line "boot=/dev/sda":
disk=/dev/sda
bios=0x80
# /sbin/lilo
Press <Ctl>+<Alt>+F1 to continue the installation
3 - Installing RR4320 driver on an Existing System
Note: If you use a SCSI adapter to boot your system, you must make sure the RR4320
controller BIOS will be loaded after that adapter's BIOS. If not, try to move it to
another PCI slot. Otherwise you may be unable to boot up your system.
Step 1 Obtain the Driver Module
You can extract the module file from the file modules.cgz on the driver disk. Using the
following commands:
# mount /dev/fd0
# cd /tmp
# gzip -dc /mnt/floppy/modules.cgz | cpio -idumv
Driver modules for all supported kernel versions will be extracted. You can find the
driver module for your running kernel under the directory that matches your kernel
version (/tmp/'uname –r'/hptiop.ko).
Linux Driver Support
6-16
Hide quick links:
Advertisement
Table of Contents
