HighPoint RocketRAID 4320 User Manual page 57

can be found on the SLES Linux CD (under /dosutils). Just run it under a command
window and follow its prompt.
On a Linux system, you can use the "dd" command to make the driver diskette. Insert a
floppy disk into the floppy drive and type the command:
# dd if=rr3xxx_4xxx-sles.img of=/dev/fd0
Step 4 Install SLES Linux
1. Start installing by booting from SLES installation CD.
2. When CD boots, select "Installation" option and press F6 to load the driver.
3. Insert the Driver Disk when it displays "Please insert the Driver Update floppy".
4. When Diver Update Menu pop-up, press "OK" and "back" for back to installer.
5. Continue the installation as normal. You can refer to SLES Linux documents about
OS installation.
Additional Installation Notes
The system device mapping order is the same as the order shown in RR4320 BIOS
Setting Utility. If you have no other SCSI adapters installed, the device marked as
"BOOT" or "HDD0" will be /dev/sda, "HDD1" will be /dev/sdb, "HDD2" will be /
dev/sdc, etc. When creating mount points, you must mount /boot on /dev/sda.
3 - Installing RR4320 Driver on an Existing System
If you are currently running Linux and would like to access drives or arrays attached
to the Rocket RAID 4320 controller, you can perform the following steps.
Note:If you use a SCSI adapter to boot your system, you must make sure the RR4320
controller BIOS will be loaded after that adapter's BIOS. If not, try to move it to
another PCI slot. Otherwise you may be unable to boot up your system.
Step 1 Update Grub
If you are running SLES SMP System, you must update /boot/grub/menu.lst first.
Linux Driver Support
6-10