Table of Contents
Advertisement
Step 2. Attach the canopy to the crossbar mounting
bracket with three of the 8-32 x 2
and canopy lock washers.
Tighten the screw firmly by hand only.
CANOPY
HATCH
CANOPY SCREW
(4)
CANOPY LOCK WASHER
(4)
Note: On sloped ceilings, align
the canopy opening towards
the top or room peak.
FAN PREPERATION & PERMA•LOCK™ HARDWARE
ALLEN SET SCREW
1
1
-20 X
"
/
/
4
4
(PRE-INSTALLED)
Prepare for fan installation as follows:
Step 3. Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread
that is designed to lock completely
when correctly installed.
Step 4. Using the provided allen wrench, loosen the
top set screw several turns to allow installation of the
downrod.Thread the downrod into the motor coupling
until it stops turning, this will take at least four and a
half full turns.
Step 5. Securely tighten the top set screw with the
provided allen wrench to ensure safe operation of your
fan.
CAUTION: Failure to fully lock in the downrod
before securely tightening the allen set screw
may cause the fan to separate from the downrod
during normal operation! See step 4 & 5.
4
CANOPY INSTALLATION
1
" long canopy screws
/
4
CANOPY
CANOPY
WASHER
3mm
ALLEN WRENCH
DOWNROD & BALL
CANOPY
LOCK
CANOPY
SCREW
ASSEMBLY
TAPERED
THREAD
MOTOR
COUPLING
ALLEN
SET SCREW
CROSSBAR
MOUNTING
BRACKET
MOTOR WIRES
GROUND
WIRE
DOWNROD
& BALL
ASSEMBLY
WARNING! DO NOT
REMOVE THIS LABEL
AND TAMPER WITH
ANTI-ROTATION
BOTTOM SET SCREW!
Unscrewing the bottom
set screw may cause fan
to separate from the
motor shaft during
normal fan operation and
may cause injuries!
Hide quick links:
Advertisement
Table of Contents
