Table of Contents
Advertisement
IMPORTANT! Leave the fan in the carton until yau are ready to hang the fan.
CROSSBAR
MOUNTING
BRACKET
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you
wish to place your Casablanca fan, an approved ceiling
fixture outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support using the mounting
hardware provided with the outlet box.
CROSSBAR MOUNTING BRACKET INSTALLATION
Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box
through the crossbar mounting bracket center hole. At-
tach the bracket, with ground wire and ridges down, to
the ceiling fixture outlet box with the mounting hard-
ware included with the outlet box.
Tighten the screws firmly by hand only, being careful
not to bend the bracket by over tightening.
CAUTION: To reduce the risk
of personal injury, use only the
mounting hardware provided
with the approved outlet box
to install the crossbar mount-
ing bracket.
WARNING!
SUPPORT DIRECTLY TO
BUILDING STRUCTURE ONLY.
INSTALLATION INSTRUCTIONS
CEILING HARDWARE
WIRE NUT (4)
GETTING STARTED
CROSSBAR MOUNTING
BRACKET
M
ODENA
ADDITIONAL HARDWARE
1" x 8-32 ROUND
HEAD SCREWS
(2)
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and discon-
nect the wiring. Check the ceiling fixture outlet box to
be sure that it is marked ' Approved for ceiling fan
mounting '. If it is not, a new box must be installed.
NOTE: The fan weight is 15 pounds.
CEILING
WIRING
FLAT
WASHER
APPROVED OUTLET
BOX HARDWARE
™
2
1
" x 8-32 ROUND
/
4
HEAD SCREWS (2)
FLAT WASHER
(2)
CEILING FAN
APPROVED
WIRING BOX
RIDGE SIDE
DOWN
GREEN
GROUND
WIRE
3
Hide quick links:
Advertisement
Table of Contents
