Table of Contents
Advertisement
Step 6. To hang the fan body in the
canopy, hold the fan body firmly and
insert the ball into the canopy open-
ing. Check that no wires were
pinched. Rotate the fan body until the
slot in the nylon ball fits into the pin
opposite the canopy opening.
NOTE: The fan weight is 15 pounds.
CANOPY ELECTRICAL CONNECTIONS
Step 7a. Attach the fan wires to the ceiling fixture outlet
box wiring by twisting the bare ends of the wires together
and then securing with a wire nut. Test that the connec-
tion is secure by pulling on the wire nut. Conect in this
order:
Step 7b. Wiring Connections
• GREEN leads from mounting plate and fan to
GROUND conductor of power source. Secure with
wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceil-
ing fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire in
ceiling outlet box. Secure with wire nut.
CANOPY HATCH INSTALLATION
Step 8. Tuck the wires into the
canopy with the wire nuts pointed up-
wards, so that the WHITE and BLACK
wires are on opposite sides of the
canopy and all wires are clear of the
canopy opening.
Step 9. Install canopy hatch with the
last canopy screw and lock washer. To
do this, tilt the fan body away from the
hatch opening.Tighten the screws
firmly by hand only.
Step 10. Straighten the fan, then
check to ensure that there is no move-
ment between the canopy and ceiling
or Hang-Tru ball and top support
shaft.
HANGING THE FAN
BALL
2 BLACK WIRES
2 WHITE WIRES
CANOPY
HATCH
LOCK
WASHER
CANOPY
SCREW
™
M
ODENA
SLOT
3 GREEN
WIRES
TILT THE FAN TO
INSTALL LAST
CANOPY SCREW
PIN
WIRE NUT
5
Hide quick links:
Advertisement
Table of Contents
